4" Contoured Tall-Ette® Elevated Toilet Seat, Elongated Toilets
Elongated Model 4" Raised Toilet Seat is available to assist users in sitting down and rising up from the toilet with this comfortable, contoured seat with Slip-in bracket for added stability.
FEATURES:
Contoured shape surface for a more comfortable and supportive seat.
Lok-In-El® bolt-down bracket holds the elevated seat securely on elongated toilet bowls
Outer Rim Dimensions: 16.5" x 15.5" x 6.75"
Inside Rim Dimensions: 10" Long x 8" Wide
Available in 4" height
Weight Capacity: 300 lbs.
Designed to fit most basic model Elongated Size Toilets.
How the bracket works:
Attaches to the toilet in minutes without knobs, clamps, screws or other complicated devices. The bracket simply slides under your existing toilet seat hinge pin. (Full inner ring contact with the bowl is not required). Your existing toilet seat will remain in the upright position.
To Install on Toilet:
1. Loosen the nuts on the toilet seat bracket that hold the toilet seat and lid to the bowl. Be sure to loosen them enough to slide the Lok-In-El® bracket between the seat and the bowl.
2. Lift the toilet seat to a raised position
and pull up slightly - approximately 3/8”.
3. Slide the Lok-In-El® bracket tongue under the seat bracket so that the wide section fits between the toilet seat screws and the two narrow sections fit outside of the screws.
4. Tighten the nuts on the screws to secure the seat and bracket. The Toilet Seat should be in contact with the china bowl with the bottom flange fitting inside the rim of the toilet bowl. Before tightening the screws, move the seat forward as much as possible to make sure the seat sits firmly in the bowl.
Note: The actual seating surface of the toilet seat is a contoured, rounded shape; however, the mounting bracket provided allows for the appropriate installation on Elongated Model toilets.
|